Airplane simulator

Mr. Zihad wasn't in USM today, so we met with Mr. Amir. He taught me how to use the airplane simulator. We're planning to fly a real airplane on Week3, so we need to get some practice with the controller. 


After that, We measured the airplane model to make a mechanical drawing by 3DCAD. I have experiences using 2DCAD but I've only used 3DCAD  a few times. 


We measured a gas turbine too. We will make a mount to it. It has one connection point above and two connections points to the side, and the draftings proceeds accordingly. 




Comments

Post a Comment

Popular posts from this blog

Cutting&Welding

Image
 We went to the workspace in the aerospace buildingsAfter finalizing the design for the drones monitor stand,  We went to the workspace in the aerospace building to start the fabrication. In the morning, we did the process of cutting the materials. the drones monitor stand consists of six parts. Mr. Shukuri cut the materials, and After that, we sanded the cut pieces of material.  After lunch break, we began welding. I studied mechanical engineering, so I had seen welding before, but it was first time in about five years. it's impressive to see something I designed come together.    
Read more

Discussion about the designs

Image
 We completed five mechanical designs last week. Today, We held a discussion regarding tehse items. I reviewed the mount of gas turbine and the stand for drone monitor with Mr.Zihad. Following discussion,  I changed the design for the drone monitor stand, as it lacked sufficient stability. I added another support post. I also changed the connection from welding to bolts where the posts join the main monitor support. original design revised desgin We tried to control a drone in the evening. It was my first time, as I've never had the chance before because the drone regulations in Japan is very strict. I was so excited!! Mr. Zihad taught me hoe to use the controller. After that, we went to a field to fly the drone. Sakai did first and then I  did. Whenever we made a mistake with the controls, Mr. Zihad would take over. I felt the adrenalin rush. It was a valuable experience. 
Read more

Assembly is complete

Image
 We continued assembly for the drone monitor stand. In the morning, we drilled the screw holes by a machine. We were able to drill the hole perfectly. After that, we did welding of the pole to be installed in the centre. After wiping the oil from the pillar, I painted it yellow. This completes one of our projects. It has ben a very successful experience. 
Read more